prlctl set

This command is used for setting Container parameters.

Syntax

prlctl set <CT_ID> <option> <value>

where <CT_ID> is Container ID.

The command options specified in this file can be subdivided into the following categories:

• miscellaneous
• networking
• resource management
• hard disk drive management

Note: The current version of Virtuozzo does not support using some options with the prlctl set command (e.g., --ext_ipadd or --disabled). If you run prlctl set with such an option, the command will notify you that the option is not supported. In this case, you can execute the vzctl set command instead.